Fastening The Mount - Kaco blueplanet 92.0 TL3 US Manual

Manual
Legend
1 Hood
2 Upper side section
3 Clip lock (4x)
↻ The device is transported to the installation location.
1. Remove the plastic strap from the pallet and packaging.
2. Pull the clip lock off the packaging.
3. Pull the hood upwards to remove it and place the cardboard packaging to one side together with the mount and ac-
cessories.
4. Set the device upright with the base section and side sections.
5. Remove the uppermost side section and base section from the device.
ð If the device is in the correct installation position: Proceed with the installation of the mount.
6.3

Fastening the mount

WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seriously
injured.
1. Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are only
to be used for masonry and concrete.
2. Only install the device in an upright hanging position.
6 1/32"
2 61/64"
B
A
D
C
Fig. 16: Minimum clearances for wall mounting
Legend
1 Mount
2 Fastening anchors [S12-Ø0.47 In / 0,98 In ]
3 Lock washer
A Minimum clearance: 4.72 In
Recommended clearance: 15.75 In
B Minimum clearance: 11.81 In
C Minimum clearance: 19.69 In
D Recommended clearance: 39.37 In
KACO blueplanet 92.0 TL3 US KACO blueplanet 110 TL3 US KACO blueplanet 125 TL3 US
2
1
A
6
3
4
5
A
Detail A
5
Assembly and preparation | 6
4 Base section
5 Lower side section
6 Cardboard packaging with mount and mounting kit
21.65 In
17.83 In
18.03 In
41.97 In
2)
60,74 In
1)
18.70 In
1)
10.63 In
1)
18.70 In
1)
10.63 In
Fig. 17: Wall mounting
4 Screw for mounting (4x) [SW 13 / [See sec-
tion 6.3} Page 21]]
5 Securing screw (1x)
6 Lug to mount the device
1)
Minimum clearance excluding device:10.63 In
1)
Recommended clearance excluding device:18.70 In
- -
- -
²) Recommended clearance with DC breaker:60,74 In
1
5
6
Page 21