Installing And Securing The Device - Kaco blueplanet 92.0 TL3 US Manual

6 | Assembly and preparation
↻ Cardboard packaging with mount and mounting kit removed from the packaging and opened.
1. Check condition and minimum room height according to specified dimensional data.
2. Mark the suspension position on the wall surface according to the bore holes in mounting plate.
. NOTE: The minimum clearances between two devices, or the device and the ceiling/floor have already
been taken into account in the diagram.
3. Fix the mount to the wall using suitable mounting fixtures from the mounting kit.
. NOTE: Make sure that the mount is oriented correctly.
ð Proceed with the installation of the device.
6.4

Installing and securing the device

CAUTION
Risk of injury from improper lifting and transport.
Lifting the device improperly can cause the device to topple and fall over.
1. Only ever raise the device vertically using the openings provided.
2. Use a climbing aid for the chosen installation height.
3. Wear safety gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation mode
due to insufficient ventilation and the resulting heat build-up.
1. Observe the minimum clearances and provide for sufficient heat dissipation.
2. Any objects on the housing of the device must be removed prior to operation.
3. Make sure that foreign objects cannot hinder heat dissipation following installation of the device.
2
Fig. 18: Lifting the device by the opening
Legend
1 Opening
2 Center of gravity
Lifting and mounting the device
↻ The mount has been installed.
Page 22
3
1
Fig. 19: Fitting the device onto the mount
3
4
KACO blueplanet 92.0 TL3 US KACO blueplanet 110 TL3 US KACO blueplanet 125 TL3 US
Manual
3
Mounting bracket
Mount
4