Kaco blueplanet 92.0 TL3 US Manual page 42

8 | Start-up
F NOTE: Please do not under any circumstances connect the Ethernet cable to the unshielded RJ45 slot
marked J200 as this typically causes damage to the printed circuit board!
1. Launch the browser on the terminal device and enter the IP address of the device:
1. http://<Geräte-IP-Adresse> (if ports LAN1 or LAN2 have been used)
2. http://169.254.1.1 (if the port marked CON700 has been used)
ð The device configuration page is displayed.
8.4.3 Start-up via a USB memory stick
Application
The installation technician has saved a pre-prepared device configuration on a USB memory stick (e.g. a configuration that
he has uploaded during the guided installation of a device or one that has been given to him by a third party).
Required components
– USB memory stick with pre-prepared start-up configuration file.
Procedure
1. Connect the USB memory stick to the USB slot on the underside of the device.
ð The device checks the saved configuration and emits a flash code via the LEDs on the front of the device which al-
lows conclusions to be drawn about the validity of the configuration ( [See section 9.2} Page 47]).
2. Bei gültiger Konfiguration werden die Parameter übertragen.
ð Once the parameters have been adopted and the device has been restarted, the device is put into operation.
8.4.4 Starting up a network
MODBUS RTU
RS485
STRING
DC
COMBINER
Fig. 48: Start-up via a network without Segment Controller
Application
If the device is to be integrated into an existing network, then the configuration shown in the figure should be used. It is
immaterial whether port LAN1 or LAN2 is used.
Required components
– A notebook that is logged into the external network.
– Ethernet cable (uncrossed patch cable)
The device can also be operated without an external Segment Controller or data logger. In this case however, the internal
logging options are limited and log data are only available for a certain period of time.
Page 42
INVERTER
Ethernet Port 0
(Static IP)
CON700
KACO blueplanet 92.0 TL3 US KACO blueplanet 110 TL3 US KACO blueplanet 125 TL3 US
Manual
LAN2
LAN1
Ethernet
External
Network/
Intranet
Intranet