Installation; General; Opening The Device; Surveying The Connection Area - Kaco blueplanet 92.0 TL3 US Manual

7 | Installation

7 Installation
7.1

General

↻ NOTE: S version: Gerät extern am Stringsammler abschalten.
1. Switch the DC isolator switch from 1 (ON) to 0 (OFF).
2. Press in the safety catch (1) from behind.
3. Attach the hanging lock (2) to the safety catch.
. DANGER! A measurement in a live state may be required for tests.
Only appropriately qualified electricians authorised by the mains
supply network operator are permitted to open and maintain the de-
vice.
. DANGER! Observe all safety regulations for protection against con-
tact with live parts.
7.2

Opening the device

↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
F Undo the 6 screws (2) and carefully remove the housing cover (1) [ T_25]
F Be careful not to damage or soil the seals or optical fibers when setting the hous-
ing cover down.
ð Proceed with the installation of the device.
7.3

Surveying the connection area

The connection point for the AC supply is situated inside the housing. The DC input source is also connected inside the
housing.
6
5
4
Fig. 22: Connection area on DC side (left) / AC side (right)
Key
1 AC connection point
2 AC overvoltage protection base
3 AC earthing bolt
Page 24
6
5
1
2
4
3
Fig. 23: Connection area (XL - Version)
4
5
6
KACO blueplanet 92.0 TL3 US KACO blueplanet 110 TL3 US KACO blueplanet 125 TL3 US
Manual
Fig. 20: Secure the DC isolator
switch to prevent it from being
switched back on
1 Switch with securing bracket
2 Padlock
Fig. 21: Removing the housing
cover
max. 3,14 In
DC connection point
DC overvoltage protection
PID connection point
1
2
1
2
1
2
3