Table of Contents
Advertisement
BioOptix™ 10
Section 1 Introduction
1.2 System Specifications
a
Dimensions
a,b
Weight
a,c
Power Requirement
The power switch is the
disconnect device.
Line Frequency
a
Operating Temperature
a
Humidity
Gradient Flow Rate Range
Flow Rate Accuracy
Gradient Accuracy
Gradient Linearity
Operating Pressure
Flow Cell Path Length
Detector Wavelength
Detector Noise
Detector Drift
CE Conformity Specifications
a. Excludes Foxy 200 Fraction Collector and Windows PC Controller. Refer to the respective manuals for these additional
specifications.
b. Dry weight of the BioOptix 10, excluding connection cables, tubing, and user-supplied buffer containers.
c.
Operating voltage of the BioOptix 10 is factory set.
d. Refer to the CE Declaration of Conformity, at the back of this manual, for applicable standards and test results.
1-2
Table 1-1 lists the BioOptix 10 specifications.
Table 1-1 BioOptix 10 Specifications
Height: 69 cm
Width: 72 cm
Depth: 61 cm
210 kg
100 VAC ±10%, 2.0 Amps
117 VAC ±10%, 2.0 Amps
234 VAC ±10%, 1.0 Amps
50 or 60 Hz
5 to 40°C
When connected to mains power, 95% relative humidity maximum at 5 to
40°C
0.5 to 12 mL/min
± 5% full scale (using water)
± 5% full scale (using water)
± 5% full scale (using water)
0 to 6.895 bar (0 to 100 psi)
2 mm
190 to 360 nm
5 × 10
-4
AU
1 × 10
-3
AU/hr
a,d
Pollution Degree: 2
Installation Category: II
Maximum Altitude: 2000 meters
Advertisement
Table of Contents
