Table of Contents
Advertisement
2400 Series Fiber Converter Manual
2405EO-HD SMPTE292M Re-Clocking Electrical to Fiber Converter
4.
STATUS LEDS
ACTIVE SIGNAL:
This Green LED will be On when there is a valid signal present at the module input.
NO CARRIER:
This Red LED will be On when there is no valid signal present at the module input.
SIGNAL WEAK:
This Yellow LED will be On when the cable equalizer detects that the cable length is
greater than a preset threshold. (Factory set for 125 meters of Belden 1694 or
equivalent cable). See section 5.2 for information on adjusting the cable equalizer
warning threshold.
LASER FAULT
This Red LED will be On when there is a fault in the optical output device.
2405EO-HD-8
Revision 1.3
Advertisement
Table of Contents
