Status Leds - evertz 2405EO Instruction Manual

Smpte259m re-clocking electrical to fiber converter

Hide thumbs Also See for 2405EO:

Table of Contents

STATUS LEDS

ACTIVE SIGNAL:

This Green LED will be On when there is a valid signal present at the module input.

NO CARRIER:

This Red LED will be On when there is no valid signal present at the module input.

SIGNAL WEAK:

This Yellow LED will be On when the cable equalizer detects that the cable length is

greater than a preset threshold. (factory set for 250 meters of Belden 8281 or

equivalent cable). See section 5.2 for information on adjusting the cable equalizer

warning threshold.

LASER FAULT:

This Red LED will be On when there is a fault in the optical output device.

2405EO SMPTE259M Re-Clocking Electrical to Fiber Converter

Revision 2.1

2400 Series Fiber Converter Manual

2405EO-9

Table of Contents