Table of Contents
Advertisement
7700 MultiFrame Manual
7700DA4-SLKE(-HD) HD/SD-SDI StreamLINK® MPEG-2/H.264 Encoder over IP
5.
STATUS LEDS
The 7700DA4-SLKE has six LED Status indicators on the front card edge to show operational status of the
card at a glance.
Two large LEDs on the front of the board indicate the general health of the module.
LOCAL FAULT:
This Red LED indicates poor module health and will be On during the absence of a
valid input signal or if a local input power fault exists (i.e.: a blown fuse). The LOCAL
FAULT indication can also be reported to the frame through the FRAME STATUS
jumper.
MODULE OK:
This Green LED indicates good module health. It will be On when a valid input
signal is present, and board power is good.
The four small LEDs, located behind the four-digit display, are currently undefined.
The rotary encoder control is currently undefined.
Page - 14
Revision 1.2
Advertisement
Table of Contents
