5.
CARD EDGE CONTROLS
The 7714HDC module is equipped with an 8 position DIP switch to allow the user to select various
functions. All positions are assigned sequentially such that DIP switch 1 is located at the top of the DIP
switch (farthest from the card ejector). Table 5-1 gives an overview of the DIP switch functions. Sections
5.1 to 5.2 describe the DIP switch functions. The On (closed) position is down, or closest to the printed
circuit board. The Off (open) position is up, or farthest from the printed circuit board. There is also a
toggle switch and pushbutton which are used to navigate the on screen menu. (See section 6)
5.1.
SETTING THE OUTPUT VIDEO FRAME RATE
DIP switches 6 and 7 are used to set the frame rate frequency of operation.
When DIP switches 6 and 7 are both off, the frame rate can be set by either the menu system or
VistaLINK
only (they cannot be set by the DIP switches). The other three settings of DIP switches 6 and 7
®
allow setting of the frame rate manually using the DIP switches only (they cannot be set by the menu
system or VistaLINK
).
®
Off
On
1
2
DIP Switch
Function
1
2
Reserved for future use
3
4
5
6
Frame Rate Divisor Selection
7
8
VistaLINK
Table 5-1: Overview of DIP Switch Functions
DIP 6
DIP 7
Off
Off
On
Off
Off
On
On
On
Table 5-2: Frame Rate Divisor DIP Switch Settings
Revision 1.1
7714HDC High Quality Down Converter
3
4
5
6
7
8
Control Enable
®
FRAME RATES
Set by Menu or VistaLINK
59.94/29.97/23.98
50/25
Reserved for future use
7700 MultiFrame Manual
®
7714HDC - 9