Running A Logging Application; Figure 150 The Logging Measurement Screen - Measurement Running - Agilent Technologies 8163A Manual

Applications
NOTE
248
All manuals and user guides at all-guides.com

Running a Logging Application

1 You can run the logging application by pressing [Measure]. The Logging
Measurement screen, as shown in Figure 150 , appears. A progress bar shows
the proportion of the logging application that has been completed.
If the averaging time [AvgTime] is less than 100 ms for an Agilent
8163xA/B series powermeter, the progress bar and the graph are not
updated until the measurement completes.

Figure 150 The Logging Measurement Screen - Measurement Running

2 There are two softkeys available from the Logging Measurement screen.
• Press [Graph] to view a graph of the Measurement results as the results are
measured. Press [Close] to return to the Logging Measurement screen. See
"Working with Application Graphs" on page 231 for information on zooming
in and out.
• Press [Cancel] to return to the Logging Setup screen without completing the
logging application.
3 When the logging application completes, you hear a beep, an hourglass
appears momentarily. If you are viewing the Logging Measurement Screen the
available softkeys change as shown in Figure 151 .
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
The Logging Application