Self-Test; Running The Self Test - Agilent Technologies 53147A Assembly Level Service Manual

Chapter 2 Service
Troubleshooting the Instrument

Self-Test

The instrument performs a Self-Test procedure when it is powered on.
The Self-Test can also be invoked from the instrument's Menu.

Running the Self Test

1 Disconnect all cables connected to the instrument's front and rear signal
connectors.
2 Connect the power cord to the power input connector on the instrument's
rear panel and to an appropriate power source.
3 Press and release the Power button on the front panel.
4 Observe the front-panel display and note any error messages displayed.
5 When CH 2 NO SIGNAL is displayed, press and release the Shift key,
and then press and release the Menu key.
6 Press the up-arrow key or the down-arrow key repeatedly until
DO SELF TEST is displayed, and then press and release the Enter key.
7 Observe the front-panel display and note any error messages displayed.
2-30 Assembly Level Service Guide