Table of Contents
Advertisement
2U bayonet board assembly
o
If any SATA or mini-SAS cables are installed, secure the cables under the thin plastic cover along
4.
the side of the node tray.
If removed, connect the B140i SATA cable to the system board
5.
page 140).
If an accelerator power cable was removed, connect it to the bayonet board
6.
page 144).
Install any removed PCI riser cage assemblies
7.
Install the node into the chassis
8.
Connect all peripheral cables to the node.
9.
Power up the node
10.
Remove the PCI riser cage assembly
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to the server or expansion boards, power down the server,
and disconnect all power cords before removing or installing the PCI riser cage.
Single-slot left PCI riser cage assembly
To remove the component:
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
In a 2U node, remove the three-slot riser cage assembly
5.
52).
Remove the single-slot left PCI riser cage assembly:
6.
("Installing a node into the
("Power up the
nodes" on page 32).
.
("SATA and mini-SAS
("PCI riser cage assembly
chassis" on page 60).
("Three-slot riser cage
cabling" on
("Accelerator
cabling" on
options" on page 84).
assemblies" on page
Operations 48
Advertisement
Table of Contents
