Installing The Optical Drive In The Sff Chassis - HPE ProLiant DL180 Gen10 User Manual

d. Connect the optical drive cable.
11. Connect the iLO service port cable to system board.
12. Install the air baffle.
13. Install the access panel.
14. Install the server into the rack.
15. Connect all peripheral cables to the server.
16. Connect each power cord to the server.
17. Connect each power cord to the power source.
18. Power up the server.
19. If removed, install the front bezel.
The installation is complete.

Installing the optical drive in the SFF chassis

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• Optical drive option
• Optical drive cage option
• T-15 Torx screwdriver
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3.
Remove all power:
Hardware options installation
66