Defined Contents Of Digital Output Ports - Smartgen HGM9510N User Manual

7.2 DEFINED CONTENTS OF DIGITAL OUTPUT PORTS

7.2.1 DEFINED CONTENTS OF DIGITAL OUTPUT PORTS
No.
0 Not Used
1 Custom Period 1
2 Custom Period 2
3 Custom Period 3
4 Custom Period 4
5 Custom Period 5
6 Custom Period 6
7 Custom Combined 1
8 Custom Combined 2
9 Custom Combined 3
10 Custom Combined 4
11 Custom Combined 5
12 Custom Combined 6
13 Reserved
14 Reserved
15 Gas Choke On Control
16 Gas Ignition Control
17 Air Flap Control
18 Audible Alarm
19 Louver Control
20 Fuel Pump Control
21 Heater Control
22 Cooler Control
23 Oil Pre-supply Output
24 Generator Excite
25 Pre-Lubricate
26 Remote Control Output
27 Reserved
28 Sync Indication
29 Close Gen Output
30 Open Gen Output
HGM9510N/HGM9530N Paralleled Genset Controller User Manual
Table 17 Defined Contents of Digital Output Ports
Type
Details of function description please see the following
description.
Act in cranking, action time is the preset time for it.
Act when engine is starting, and disconnect when engine is
stopped.
Act on over speed shutdown and emergence stop. Air inflow
can be closed to stop the engine quicker.
Act on warning, shutdown, and trips. An annunciator can be
connected externally. If "alarm mute" configurable input port
is active, this is prohibited.
Act when genset is starting and disconnect when genset is
stopped completely.
It is controlled by limit values of level sensor fuel pump.
It is controlled by heating limit values of temperature sensor.
It is controlled by cooler limit values of temperature sensor.
Act from "crank on" to "safety on".
Output in start process. If there is no generator frequency
during high-speed running, it shall output for 2 seconds again.
Act from pre-heating to safety run.
This port is controlled by communication (PC).
It can control generating switch to take load.
It can control generating switch to take off load.
Description
Page 78 of 116