Table of Contents
Advertisement
No.
Items
16.
Gas On Delay
17.
Ignition Off Delay
18.
Smart Pre-heat
19.
Smart Start Idle
Engine Setting
1.
Engine Type
2.
Flywheel Teeth
3.
Rated Speed
4.
Loading Speed
Loss
of
Speed
5.
Signal Delay
Loss
of
Speed
6.
Signal Action
7.
Over Speed 1 Set
8.
Over Speed 2 Set
HGM9510N/HGM9530N Paralleled Genset Controller User Manual
Parameters
Defaults
(0-60)s
0
(0-60)s
0
(0-1)
0
(0-4)
0
(0-1000)
40
(0-1)
0
(0-4)
0
(0-1000)
50
(0-69)
0
(10-300)
118
(0-6000)r/min
1500
(0-100.0)%
90.0
(0-3600)s
5
(0~7)
7
(0-1)
1
(0-200.0)%
114.0
(0-200.0)%
112.0
(0-3600)s
2
(0-7)
7
(0-1)
1
(0-200.0)%
110.0
Description
engine starts.
After this period, gas valve control outputs
after the engine starts.
After this period, gas ignition control stops
outputting after the gas valve is closed.
0: Disable
1: Enable
Sensor is pre-set correlation sensor.
Set value is sensor threshold at period end.
When it is enabled, if selected sensor value
is above the set value, it shall end the
pre-heating.
0: Disable
1: Enable
Sensor is pre-set correlation sensor.
Set value is sensor threshold at period end.
When it is enabled, if selected sensor value
is above the set value, it shall end the start
idle.
Default: conventional engine (not ECU)
When the controller is connected to J1939
engine, choose the corresponding type.
Tooth number of the engine, for judging of
starter
separation
inspecting of engine speed. See the
installation instructions.
Offer standard to judge over/under/loading
speed.
Set value is percentage of rated speed.
Controller detects when it is ready to load.
It won't switch on when speed is under
loading speed.
Time from detecting speed is 0 to action
confirm.
0: None; 1: Warning; 2: Block; 3: Safety Trip;
4: Safety Trip and Stop; 5: Trip; 6: Trip and
Stop; 7: Shutdown.
0: Disable
1: Enable
Set value is rated speed percentage.
Return value is rated speed percentage.
Delay value
Action
0: Disable
1: Enable
Set value is rated speed percentage.
conditions
and
Page 60 of 116
Advertisement
Table of Contents
