Scania; Volvo Edc3 - Smartgen HGM9510N User Manual

Terminals of controller
Fuel relay output
Starting relay output
CAN GND
CAN(H)
CAN(L)
Engine type: Perkins.

22.14 SCANIA

It is suitable for S6 engine control module. Engine type is DC9, DC12, and DC16.
Terminals of controller
Fuel relay output
Starting relay output
CAN GND
CAN(H)
CAN(L)
Engine type: Scania-s6.

22.15 VOLVO EDC3

Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Terminals of controller
Fuel relay output
Starting relay output
programmable output 1
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo.
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
HGM9510N/HGM9530N Paralleled Genset Controller User Manual
Table 40 Connector
Connector
1,10,15,33,34
-
-
31
32
Table 41 B1 Connector
B1 connector
3
-
-
9
10
Table 42 "Stand Alone" Connector
"Stand alone" connector
H
E
P
Table 43 "Data Bus" Connector
"Data bus" connector
-
1
2
Remark
Connected to starter coil directly.
CAN communication
(connected with controller terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Connected to starter coil directly.
CAN communication
(connected with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
ECU power;
Set output 1 as "ECU power".
Remark
CAN communication
(connected with controller terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
shielding line
shielding line
shielding line
Page 113 of 116