Enable Definition Of Programmable Output Ports; Defined Contents Of Programmable Output Ports - Smartgen GENSET HGM8100N Series User Manual

8.2

ENABLE DEFINITION OF PROGRAMMABLE OUTPUT PORTS

8.2.1.

DEFINED CONTENTS OF PROGRAMMABLE OUTPUT PORTS

Table 14 Defined Contents of Programmable Output Ports
No.
0 Not Used
1 Custom Period 1
2 Custom Period 2
3 Custom Period 3
4 Custom Period 4
5 Custom Period 5
6 Custom Period 6
7 Custom Combined 1
8 Custom Combined 2
9 Custom Combined 3
10 Custom Combined 4
11 Custom Combined 5
12 Custom Combined 6
13 Reserved
14 Reserved
15 Reserved
16 Reserved
17 Air Flap Control
18 Audible Alarm
19 Louver Control
20 Fuel Pump Control
21 Heater Control
22 Cooler Control
23 Pre-Supply Fuel Output
24 Generator Excite
25 Pre-Lubricate
26 Remote Control Output
27 GSM Power Supply
28 Reserved
29 Close Gen Output
30 Open Output
31 Close Mains Output
HGM8100N Genset Controller User Manual
Type
Details of function description please see the following.
Action when over speed shutdown and emergence stop.
It also can close the air in flow .
Action when warning, shutdown, trips. Can be connected
annunciator externally. When "Alarm Mute" configurable
input port is active, it can remove the alarm.
Action in genset starting and disconnect when genset
stopped completely.
It is controlled by fuel pump of level sensor's limited
threshold.
It is controlled by heating of temperature sensor's
setting bound.
It is controlled by cooler of temperature sensor's setting
bound.
Action when start and running safety period.
Output in start period. If there is no generator frequency
during hi-speed running, output for 2 seconds again.
Actions in period of pre-heating to safety run.
This port is controlled by communication (PC).
Power for GSM module (GSM module is reset when
GSM communication failed).
Control generator to take load.
Control generator to off load.
Control mains to take load.
Description
Page 38 of 66