Performance And Characteristics - Smartgen HGM9510N User Manual

2

PERFORMANCE AND CHARACTERISTICS

Main characteristics are as bellow:
—
With ARM-based 32-bit SCM, high integration of hardware and more reliable;
—
240x128 LCD with backlight, multilingual interface (including English, Chinese or other languages)
which can be chosen on site, making commissioning convenient for factory personnel;
—
Improved LCD wear-resistance and scratch resistance due to hard screen acrylic;
—
Silicon panel and pushbuttons for better operation in high/low temperature environment;
—
Two RS485 communication ports enable remote control, remote measuring, remote
communication via MODBUS protocol;
—
Fitted with CANBUS port and can communicate with ECU equipped with J1939. Not only can you
monitor frequently-used data (such as water temperature, oil pressure, engine speed, fuel consumption
and so on) of ECU machine, but also control start, stop, raising speed and dropping speed via CANBUS
port;
—
Suitable for 3-phase 4-wire, 3-phase 3-wire, single phase 2-wire, and 2-phase 3-wire systems with
voltage 120/240V and frequency 50/60Hz;
—
Collects and shows 3-phase voltage of Bus/Gen, Bus/Gen frequency, Gen 3-phase current, Gen
power and Gen voltage harmonic parameters;
—
For Bus, controller has loss of phase and reverse phase sequence detection functions; For
generator, controller has over voltage, under voltage, over frequency, under frequency, high
unbalanced voltage, high total harmonic distortion, over current, earth fault, high unbalanced current,
low power factor, over power, reverse power, loss of excitation, loss of phase, reverse phase sequence
detection functions;
—
Synchronous parameters: voltage difference between bus and gen, frequency difference between
bus and gen, phase angle difference between bus and gen;
—
Multiple running modes in auto state: on load running, off load running, demand parallel running;
—
Ramp on and ramp off function in paralleling/splitting;
—
3 fixed analogue sensor inputs (temperature, oil pressure and fuel level);
—
2 configurable analogue sensor inputs can be set as sensors of temperature, oil pressure or level;
—
Oil pressure sensor
resistive/current/voltage sensors, while other sensor inputs can directly connect with resistive sensors,
and for connecting voltage/current sensors, please make it clear before the order;
—
More kinds of curves of temperature, oil pressure, fuel level sensors can be used directly and users
can define the sensor curves by themselves;
—
Precisely collect various engine parameters, including temperature, engine oil pressure, fuel level,
speed, battery voltage, charger voltage, accumulated running time and accumulated start times etc.;
HGM9510N/HGM9530N Paralleled Genset Controller User Manual
and configurable sensor input 1 can directly connect with
Page 7 of 116