Smartgen HGM9510N User Manual page 79

No.
31 Reserved
32 Reserved
33 Crank Relay
34 Fuel Relay
35 Idle Control
36 Speed Raise Output
37 Speed Drop Output
38 Energize to Stop
39 Speed Drop Pulse
40 ECU Stop
41 ECU Power Supply
42 Speed Raise Pulse
43 Crank Success
44 Gen OK
45 Gen Load Available
46 Reserved
47 Synchronizing
48 Common Alarm
49 Common Trip and Stop
50 Common Shutdown
51 Common Trip
52 Common Warn
53 Common Block
54 Battery Over Voltage
55 Battery Under Voltage
56 Charge Alternator Failure
57 Common Safety Stop
58 Common Safety Trip
59 Reserved
60 ECU Warning
61 ECU Shutdown
62 ECU Comm. Failure
63 PWM Voltage Raise
HGM9510N/HGM9530N Paralleled Genset Controller User Manual
Type
Act when genset is starting and disconnect when stop is
completed.
When gas timer is enabled, fuel relay output is used to control
gas valve.
It is used for genset with idling control. Close before starting
and open in warming up delay; Close during stopping idle
mode and open when stop is completed.
Act during warming up time.
Act between the period "stop idle" and "failed to stop".
It is used for engines with ETS electromagnet. Close when
stop idle is over and open when pre-set "ETS delay" is over.
Act for 0.1s when controller enters "stop idle", used for control
parts of ECU dropping to idle speed.
Used for ECU engine and control its stop.
Used for ECU engine to control its power.
Act for 0.1s when controller enters warming up delay; used for
control parts of ECU raising to normal speed.
Close when a successful start signal is detected.
Act when generator is normally running.
Act between normal running and high-speed cooling.
Act when controller is synchronizing.
Act when genset common warning, common shutdown,
common trip alarms occur.
Act when common trip and stop alarm occurs.
Act when common shutdown alarm occurs.
Act when common trip alarm occurs.
Act when common warning alarm occurs.
Act when battery's over voltage warning alarm occurs.
Act when battery's low voltage warning alarm occurs.
Act when charging failure warning alarm occurs.
Indicates ECU sends a warning signal.
Indicates ECU sends a shutdown signal.
Indicates controller cannot communicating with ECU.
When output type of AVR is set as "Relay output", controller
Description
Page 79 of 116