Olivetti d-Copia 3002MF plus Service Manual page 70

Section No.
Optical U072 Adjusting the DP original center
U073 Scanner motor operation check
U074 Adjusting the DP input characteris-
tics
U087 Setting the DP scanning position
change operation
U089 MIP-PG pattern output
U091 White lines correction setting
U099 Original size detection setting
High volt- U100 Main high voltage adjustment
age sys-
U101 Primary transfer voltage adjustment
tem
U108 Separation Shift bias adjustment
U110 Drum counter
U111 Drum drive time.
U117 Drum unit number
U118 Drum unit history
U127 Clearing the transfer count
Devel- U130 Developer agent initial setting
oper sys-
U136 Toner level detection setting
tem
U139 Temperature, humidity
U140 Developer bias adjustment
U147 Setting the toner applying mode
U148 Drum refresh mode setting
U150 Check Toner Sensor Operation
U157 Developer drive time
U158 Developer counter
Fuser U161 Fuser temperature adjustment
U167 Clearing the fuser count
U198 Set Fuser Phase Control
U199 Fuser temperature
Y118240-1
Maintenance item
Adjusting the center line for DP scanning
Move the scanner in the set condition
Sets the DP image scanning density
Change the scanning position as the corrective
measures for the black lines
Output MIP-PG pattern
Sets the white lines detection threshold
Sets the original size detection check and detec-
tion threshold
Adjust the drum surface potential
Sets high voltage except the main high voltage
and outputs
Adjust ON/OFF timing of separation shift bias.
Displays/sets the drum counter
Displays the drum drive time.
Displays the drum number
Displays the drum history
Displaying the counts
Installs initial toner in the developer unit
Sets the number of pages printable at toner near
end
Displays the machine inside and outside humid-
ity
Adjust the developer bias values.
Sets the overcharge toner removal mode
Setting auto drum refresh
Displays the ON/OFF status of each switch and
sensor in related toner.
Displays/sets the developer drive time
Displays/sets the developer counter
Sets the fuser control temperature
Displaying/clearing the counts
Switch the fuser phase control.
Monitor the fuser temperature
1-3-3
Outline
Service Manual