Olivetti d-Copia 3002MF plus Service Manual page 62

(9) card reader installation
ID card reader installation requires the following parts.
Card label
<Procedures>
1. After checking to press the power
source key, put out the power source
lamp and memory lamp, turn the main
power switch OFF and unplug the
power plug.
2. Detach the screw (b) and remove the
operation panel lower cover.
3. Twist in front of the A section of the card
reader cover, remove to pull in the left
direction.
Y118240-1
Parts Number
1 (Bundled main unit)
Operation panel lower cover
Screw
1-2-35
Parts number
Figure 1-2-52
Card reader cover
Figure 1-2-53
Service Manual
A