Table of Contents
Advertisement
6.[Initialize Completed] appears after setting and the
touch panel is automatically corrected.
7.After finishing setting, the [Check] screen is automati-
cally displayed.
Method: Check
Single Tap Check
1.Press the center of indicated three "+", and then check
the display position.
2.Check that the gap of the X and Y axis of the displayed
coordinate is 6 or less.
*: If out of the specified value, select [Initialize] and
press the [Start] key to return to Step.1.
Multi Tap Check
1. Select [Multi Tap Check] and press the [Start] key.
2.Press 2 points of [○] simultaneously. (Step1)
*: Displays the detected point with a red dot if it is out
of the default value.
*: If out of the specified value, select [Initialize] and
press the [Start] key to return to Step.1.
Y118240-1
Initialize
Single Tap Check.
Press the center of the "+" sign.
*Press it using a tool with a fine tip.
If you need to perform initialization again, select "Initialize" and press the Startkey.
+
Initialize
Multi Tap
Check
Single Tap Check.
Select "Mult Tap Check" and press the Startkey to go to the next step.
If you need to perform initialization again, select "Initialize" and press the Startkey.
+
(4, -1)
Initialize
Multi tap Check. Step1.
Press both circles. Finalize with both pressed at the same time.
*Press with the tips of your fingers. (NOT your fingenails)
1-3-79
Initialize completed.
+
+
(13, -3)
Step 1 : Not completed.
Step 2 : Not completed.
Service Manual
+
+
(-8, 15)
Advertisement
Chapters
Table of Contents
