Table of Contents
Advertisement
U203
Check DP operation
(Message: Check DP Operation)
Contents
Simulate the original conveying operation separately in the DP.
Purpose
Check the DP operation
Method
1.Press the [Start] key.
2.Place an original in the DP if running this simulation with paper.
3.Select the scan speed
Normal Speed
High Speed
Mode
Reset
Result
Method: Normal Speed/High Speed
4.Select the item to operate.
CCD ADP
CCD RADP
CIS
CCD ADP (Non-P)
CCD RADP (Non-P)
CIS(Non-P)
5.Press the [Start] key.
*: The operation starts.
6.To stop the operation, press the [Stop] key.
Setting: Mode
1.Select the item to set.
On
Off
2.Press the [Start] key to set the setting value.
Method: Reset
1.Select [Execute].
2.Press the [Start] key to reset.
Y118240-1
Items
Normal scanning (600dpi)
High speed scanning
Set the conveying timing inspection mode
Reset the conveying timing inspection data
Check the conveying timing
Items
With paper, a single-sided original is fed to the CCD
With paper, a double-sided original is fed to the CCD
With paper, a double-sided original is fed to the CIS
Without paper, a single-sided original is fed to the CCD (continuous
operation)
Without paper, a double-sided original is fed to the CCD (continuous
operation)
Without paper, a double-sided original is fed to the CIS (continuous
operation)
Items
Set the conveying timing inspection mode to On
Set the conveying timing inspection mode to Off
Contents
Contents
Contents
1-3-81
Service Manual
Advertisement
Chapters
Table of Contents
