Olivetti d-Copia 3002MF plus Service Manual page 425

(4-2) Fitting the scanner wires
NOTE
When fitting the wires, be sure to use those specified below.
Machine front:(P/N:AVGR26453D), gray
Machine rear:(P/N:AVGR26452H), black
Fitting requires the following tools
Two frame securing tools (P/N AVGR12740X)
Two scanner wire stoppers (P/N AVGR26423A)
Procedures
1. Remove the screw and remove the
scanner wire drum gear.
2. Remove the screw at two scanner wire
drums.
3. Remove the stop ring and bush from
the front of the scanner wire drum shaft.
4. Remove the scanner wire drum shaft
from the scanner unit.
Y118240-1
Scanner wire
drum shaft
Screw
Bush
Scanner
Stopring
wire drums
1-5-51
Scanner wire
drum gear
Screw
Scanner unit
Figure 1-5-86
Service Manual
Screw