Table of Contents
Advertisement
Setting: T2 Time Out
The T2 time-out time is specified as follows.
From CFR signal output to image data reception
From image data reception to the next signal reception
In ECM, from RNR signal detection to the next signal reception
1.By using the [+] [-] keys or the numeric keys, change the setting value.
Sets the T2 time-out time.
2.Press the [Start] key to set the setting value.
*: [Completed] is displayed.
Setting: Ta Time Out
Sets the time to start ringing for an operator through the external telephone after receiving a call in the FAX/
telephone automatic switching mode. (See figure 1-3-18). If either receiving a FAX signal within this time or
passing this time, the mode automatically switches to the FAX reception mode. Execute when a reception
error occurs when in the automatic FAX/telephone switching.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
Sets the Ta time-out time.
2.Press the [Start] key to set the setting value.
*: [Completed] is displayed.
Setting: Tb1 Time Out
Sets the time to start sending the ring back tone after receiving a call as a fax machine in the FAX/tele-
phone automatic switching mode, (See figure 1-3-18). Execute when a reception error occurs when in the
automatic FAX/telephone switching.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
Sets the Tb1 time-out time.
2.Press the [Start] key to set the setting value.
*: [Completed] is displayed.
Setting: Tb2 Time Out
Service Manual
Contents
Contents
Tb1
Tb2
Figure 3-24 Ta/Tb1/Tb2 time-out time
Contents
1-3-174
Setting
1 to 255
Setting
1 to 255 s
Ta
Setting
1 to 255
Initial
range
setting
69
Initial
range
setting
30
Initial
range
setting
20
Y118240-1
Advertisement
Chapters
Table of Contents
