Huawei NE05E Hardware Manual page 535

HUAWEI NE05E,NE08E
Hardware Guide
NE08E-S6E's Device status:
-------------------------------------------------------------------------------
Slot # Type
-------------------------------------------------------------------------------
1
5
6
7
8
9
11
-------------------------------------------------------------------------------
----End
Follow-up Procedure
After replacing a part, collect the tools. If the part is faulty, maintenance personnel
should fill in the Offsite Repair Card for Faulty Materials, and send the card and
the faulty part to Huawei for timely maintenance.
4.1.2.4.2 Replacing the Control Board without 1+1 Protection Mode
Impact on the System
Services will be interrupted for about 15 minutes when replacing a control board
without 1+1 protection mode.
Precautions
Avoid direct eye exposure to the laser beam launched from the optical interface
board or fiber.
● To ensure valid part replacement, when replacing the control board, contact
● When replacing a part, make sure that the interface is not connected to any
● Optical interfaces and optical fiber connectors must be clean. Optical fiber
Tool
●
●
●
Issue 05 (2023-03-31)
Online Register
PIC Present Registered Normal
PIC Present Registered Normal
PIC Present Registered Normal
CXP Present Registered Normal
CXP Present Registered Normal
PWR Present Registered Abnormal OTHER 0
FAN Present Registered Abnormal OTHER 0
D ANGER
NO TICE
Huawei engineers to determine whether a license needs to be applied for. You
can apply for a license or use Stick License to activate some license control
items.
optical fibers or cables.
connectors must be properly capped to keep dusts away.
ESD wrist strap or ESD gloves
Phillips screwdriver
ESD bag
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Status Role LsId Primary
OTHER 0 NA
OTHER 0 NA
OTHER 0 NA
MMB 0 Master
MMB 0 Slave
NA
NA
527