Huawei NE05E Hardware Manual page 442

HUAWEI NE05E,NE08E
Hardware Guide
Precautions
Removing a working board may affect the equipment or interrupt services.
Procedure
Step 1 Wear the ESD wrist strap properly according to
Step 2 Loosen the captive screws on the front panel with the Phillips screwdriver until the
screws spring out. Then, rotate the ejector levers of the board to the open position
with two hands when the board disconnects to the socket. See
Step 3 Remove the board with stable force. See
Figure 4-14 Removing a board
Step 4 The removed board must be put into an ESD box or ESD bag. If the empty slot
does not house any other board, install a filler panel onto the slot according to
Installing a Filler
----End
Installing a Filler Panel
The empty slot should be covered with a filler panel to ensure proper EMC and to
keep dust away.
Prerequisites
None
Tools, Instruments, and Materials
ESD wrist strap, Phillips screwdriver
Procedure
Step 1 Cover the filler panel onto the empty slot.
Step 2 Drive on the captive screws on the filler panel according to
Issue 05 (2023-03-31)
CA UTION
Panel.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure 4-11.
Figure 4-14.
Figure 4-14.
Figure 4-15.
434