Huawei NE05E Hardware Manual page 436

HUAWEI NE05E,NE08E
Hardware Guide
Unpacking the Chassis
Unpack the chassis before starting the installation.
Prerequisites
The chassis must be delivered to the site.
Tools, Instruments, and Materials
●
●
●
Precautions
● Integrated circuits (ICs) are sensitive to electrostatic discharge from the human
● If the equipment is transported from a cold and dry place to a warm and damp
Procedure
Step 1 Transport the packing box to the equipment room.
Step 2 Check the packing box, and stop unpacking it in any of the following cases:
●
●
Find the causes and provide feedback to the local representative office of Huawei.
Step 3 Observe the labels on the carton to check the equipment configuration and take a
record.
Step 4 Cut the strap with the diagonal plier and then split the adhesive tape properly
along the seam between the cover and the body of the box with the paper knife.
Do not scratch the articles inside the box.
Step 5 Open the carton and take out the chassis box from the carton.
Step 6 Open the chassis box and take out the chassis. Then, check whether the chassis is
damaged.
----End
Unpacking Boards
If the board is separately delivered, unpack the board before you install it.
Issue 05 (2023-03-31)
ESD gloves
Diagonal pliers
Paper knife
NO TICE
body. When handling boards or metallic parts of the equipment, wear ESD
gloves and hold only the edges of the boards during operation.
place, wait at least 30 minutes before unpacking it. Otherwise, the moisture
condenses on the board surface and damages the components.
The outer package is severely damaged.
There is water leakage on the outer package.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
428