Huawei NE05E Hardware Manual page 441

HUAWEI NE05E,NE08E
Hardware Guide
Step 2 If a slot is covered with a filler panel, loosen the two captive screws using a
screwdriver until the screws spring out. Then, remove the filler panel.
Step 3 Rotate the ejector levers on the front panel of the board to the open position with
both hands.
Step 4 Push the board gently into the slot along the guide rails. Then, push the front
panel of the board up to end when the board engages with the socket on the
backplane. See
Figure 4-12 Inserting a board
Step 5 Rotate the ejector levers to the close position.
insertion of the board.
Step 6 Tighten the captive screws on the board, as shown in
the board is complete.
Figure 4-13 Tightening captive screws on the board
----End
Removing a Board
This section describes how to remove a board.
Prerequisites
The fibers or cables connected to the board must be removed.
Tools, Instruments, and Materials
ESD wrist strap, Phillips screwdriver, ESD box or ESD bag
Issue 05 (2023-03-31)
Figure 4-12.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure 4-13
Figure
shows the expected
4-13. Installation of
433