Huawei NE05E Hardware Manual page 327

HUAWEI NE05E,NE08E
Hardware Guide
7.
8.
9.
10. Implement 1+3+3 waterproof protection where the coaxial cable and the
3.6 Cables
This chapter describes various optical fibers and cables used on the equipment.
3.6.1 Power Supply Cables and Ground Cables
This section describes power supply cables and ground cables used on the
equipment.
3.6.1.1 DC Power Cables (TB2PIN Terminal)
DC power cables are used to provide external power supplies for the NE.
Power cables need to be produced on site. The power cables are made of DC
connectors, single cord end terminals, and wires.
appearance of the power cable.
of the power cable.
Figure 3-81 Appearance of the power cable
Issue 05 (2023-03-31)
Route the jumper through the cable inlet on the right side of the floor of the
cabinet, and connect the GPS feeder to the AE 905S.
Insert the AE 905S module into an optical interface of the device with the
latch of the AE 905S module locked.
Connect one end of the GPS feeder to the Surge interface of the surge
protector and the other end of the GPS feeder to the GPS antenna. Fasten
each connector with a wrench.
Protect interface of the surge protector are connected and fasten cable ties at
both ends.
– Implement waterproof protection where the feeder connector and the
Surge interface of the surge protector are connected.
– Implement waterproof protection where the feeder connector and the N
joint of the GPS antenna are connected.
NO TE
For details about how to make a GPS feeder connector, see the GPS quick
installation guide.
Copyright © Huawei Technologies Co., Ltd.
Figure 3-81
Table 3-340 provides the technical specifications
3 Hardware Description
shows the
319