Huawei NE05E Hardware Manual page 497

HUAWEI NE05E,NE08E
Hardware Guide
Figure 4-82 Aligning the stripped twisted pair cable
● When stripping the sleeve of the twisted pair cable, do not scratch the shield
● When stripping the shield layer, do not scratch the insulation layer covering the
Step 3 Insert the cable B with the aligned twisted pairs into the connector plug A and
crimp the connector with a crimper, as shown in
Figure 4-83 Crimping the connector
Step 4 A network cable may be either a crossover cable or a straight-through cable.
Which operations should be performed at the other end depends on the network
cable type.
●
●
----End
Issue 05 (2023-03-31)
NO TICE
layer.
twisted cores.
To assemble a straight-through cable, repeat Steps 1-3 to make the cable
components at the other end.
To assemble a crossover cable, perform the following operations.
a. Repeat Step 1.
b. Repeat Step 2. In Step 2, for the wire sequence, refer to the mapping
relation of the crossover cables in
c. Repeat Step 3 to make the cable components at the other end.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure 4-83.
Table 4-34.
489