Huawei NE05E Hardware Manual page 470

Hide thumbs Also See for NE05E:

Table of Contents

HUAWEI NE05E,NE08E

Hardware Guide

Figure 4-33 Install binding strap on cutterbar

1. Binding strap

Step 2 Roll the binding strap and allow it to pass through the guiding trough of the

Step 3 Cut the binding strap into appropriate length by slantly hauling the binding strap

towards the cutter tooth of the cutterbar, as shown in

Figure 4-34 Cut the binding strap

1. Binding strap

Bundling the Binding Strap

This section describes how to bund the binding strap.

?.1. Procedures for Bundling the Binding Strap

This procedure describes how to bind bundling of the binding strap

Prerequisites

Issue 05 (2023-03-31)

2. Plastic axis

2. Guiding trough

4 Hardware Installation and Parts Replacement

3. Cutterbar

3. Cutter tooth

Table of Contents