Huawei NE05E Hardware Manual page 486

HUAWEI NE05E,NE08E
Hardware Guide
Step 6 Push the crimping sleeve toward the connector. Crimp the external conductor of
the coaxial cable tight. Use the crimper to tighten the crimping sleeve and the
coaxial cable connector, as shown in
female connector is assembled with the coaxial cable.
If the diameter of the cable that matches the connector plug is 2.2 mm and that of the coaxial
cable is 1.6 mm, crimp the external conductor of the coaxial cable twice by using the crimper
with a jaw of 2.5 mm. That is, crimp the external connector, rotate it by 90 degree, and then
crimp it again.
Figure 4-62 Crimping the external conductor
----End
?.4. Testing Cable Connectivity
This section describes how to test the cable connectivity by using a multimeter.
Prerequisites
During the process of routing or bundling cables, and installing the connector, the
circuit on the cable may become open or broken. Hence, after the preceding
procedures are completed, test the connectivity of cables.
Tools, Equipment and Materials
Multimeter
Background Information
In this section, the cable has a Anea 96 connector at one end and a group of SMB
connectors at the other, as shown in
test the cable connectivity by using a multimeter.
Procedure
Step 1 Set the multimeter to the resistance gear.
Step 2 On the SMB connector side, connect the two probes of the multimeter to the
internal and external conductors respectively.
Issue 05 (2023-03-31)
NO TE
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure 4-62. In this way, the straight SMB
Figure 4-63. This section describes how to
478