Huawei NE05E Hardware Manual page 439

HUAWEI NE05E,NE08E
Hardware Guide
Table 4-15 Board checklist
Item
Name and quantity
Outer view
Connector
Step 6 If no problem is found, put the board back into the board box and put it in the
place specified by the customer.
●
●
----End
Requirements of Inspection
The received goods must be inspected against the
●
●
●
4.1.1.3.2 Installing chassis
The installation modes for chassis vary with installation environment.
Issue 05 (2023-03-31)
If you are going to install the board right after unpacking, place the board on
an ESD surface to discharge the static electricity.
If you are going to install the board at a later time, pack the board using the
original materials and place them at a cool dry place without direct sunshine
or strong electromagnetic radiation.
After the goods are inspected complete and intact, both the engineering
supervisor and the customer must sign the
customer takes over the goods.
During the inspection, if some equipment is stated undelivered in the
List , directly report the situation to the order management engineer of the
local office of Huawei for subsequent handling. Both the engineering
supervisor and the customer shall sign the
situation.
If any short, wrong, extra or damaged equipment is found during the
parties shall sign the Unpacking Memo and the Packing List .
inspection, both
The project supervisor shall fill in the
to the order management engineer of the local office of Huawei within three
days.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Requirement
The board name and quantity should
be in line with the contract or packing
list.
The board should be clean and free of
any scratch, loose component, or
damage.
The connector should be properly
installed and free of tilted or deformed
pins.
Packing List item by item.
Packing List . After that, the
Packing List to confirm the
Equipment Problem Report and send it
Packing
431