Huawei NE05E Hardware Manual page 450

HUAWEI NE05E,NE08E
Hardware Guide
embossment of 0.2 mm x 0.6 mm around (symmetric on both sides), and the area
in the middle is for attaching the label, as shown in
Figure 4-17 Label for power cables
1.Cable tie
Information Carried on Labels
This section gives the information carried on labels for signal cable and power
cable.
?.1. For Power Cables
Labels for power cables are only attached on one side of the identification plates.
On the labels, there is information (the part after the mark "TO:") about the
location of the device on the other end of the cable, like the location of control
cabinet, distribution box or power socket.
?.2. For Signal Cables
The two sides of the label attached on the signal cable carry information about
the location of the ports connected to both ends of the cable.
The information is given like this:
●
●
●
Printed parts on the label for signal cables, as shown in
Issue 05 (2023-03-31)
Area 1 contains the location information of local end of the cable.
Area 2 (with the mark "TO:") contains the location information of the
opposite end of the cable.
Area 3 has been folded up inside the label.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
2.Label
Figure 4-17.
3.Dividing line on the label
Figure 4-18.
442