Huawei NE05E Hardware Manual page 453

HUAWEI NE05E,NE08E
Hardware Guide
Requirements on the Printer
To print the labels, laser jet printer must be used, although there is no restriction
on the model of the printer. Before printing the label, set up the page and try the
printing on ordinary blank paper (both sides are blank):
1.
2.
3.
Figure 4-20 Warning prompt before printing
If the printout conforms to the requirement, print it to label paper. If the printout
does not conform, adjust the page setup and try the printing again, until the
correct printout is produced. The method of adjusting the page setup is as follows:
1.
2.
3.
4.
After the page setup has been made correct, save it for future use. This page setup
is only necessary the first time you use the template to print the labels.
Requirements on the Printed Label
After you print the labels, check whether they comply with the template
specifications:
●
●
●
Issue 05 (2023-03-31)
Cover the blank paper onto the whole page of label paper, and check whether
the page setup conforms to the requirement.
Make sure the printer properties, such as "paper size" and "direction", have
been set correctly.
If the warning prompt as shown in
Ignore to continue the printing.
Select the menu item File > Page Setup.
Select the Margins tab page.
Select Left for Gutter Position.
Set Header and Footer to 0, and adjust the values of Top, Bottom, Left, and
Right.
All the printouts must be on the label, and nothing should be printed on the
bottom page of the label.
Contents in the cells should be aligned in the center. In a single-line printout,
the dividing lines and the mark "TO:" should not be covered by the printed
characters.
When the cells are merged and the printouts are made in multiple lines, avoid
covering the mark "TO:" when printing the texts by using the space bar to
move the printing contents to the next line.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure 4-20 appears before printing, click
445