Huawei NE05E Hardware Manual page 451

HUAWEI NE05E,NE08E
Hardware Guide
Figure 4-18 Label for signal cables
Seen from the cabling end of the equipment, the text part of the label is on the
right side of the cable. The side with "TO:" that is facing outside carries the
location information of the opposite end, and the other side carries the location
information of the local end. Therefore, the information in Area 1 at one end is
the same as the information in Area 2 at the other end of the cable, and vice
versa. In other words, the local information at one end is called the opposite
information at the other end.
?.3. Remarks
To use labels, focus on the following points.
●
●
●
●
●
Filling Information on Labels
This section describes how to fill information on labels. The contents can be
printed or written on the labels. Printing is recommended for the sake of high
efficiency and eye-pleasant layout.
?.1. Printing Labels
Use a laser printer to print the label according to the template.
Template for the Printing
Template is available to print out the label. You can obtain the template by:
●
●
Issue 05 (2023-03-31)
When printing/writing and attaching labels, pay attention to keep the labels
clean.
Since the label paper is made of moistureproof and waterproof material, ink-
jet printers and ink pens are forbidden for printing and writing labels.
Labels should be attached with good order in alignment.
Cable ties should be bundled in the same position of power cables, with
identification plates on the same side.
The positions of "up", "down", "right" or "left" are all based on the viewpoint
of the engineering person who is working on the label.
Downloading the template from http://support.huawei.com. The directory of
the template is Documentation > Engineering Service > Engineering Quality >
Quality Standard and Template.
Asking for the template from Huawei local office.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
443