Huawei NE05E Hardware Manual page 491

HUAWEI NE05E,NE08E
Hardware Guide
Figure 4-68 Leading the network cable through the connector external sleeve
Step 2 Strip a 300 mm length of the external sleeve E and cut the nylon rip cord inside
the external sleeve. Make a 5 mm cut on the cable external sleeve, as shown in
Figure
Figure 4-69 Stripping the external sleeve of the twisted pair cable
● When stripping the sleeve of the twisted pair cable, do not scratch the shield
● When stripping the shield layer, do not scratch the insulation layer covering the
Step 3 Lead the connector metal sleeve B through the twisted pair cable. The sleeve
should envelop the shield layer F, as shown in
Issue 05 (2023-03-31)
4-69.
NO TICE
layer.
twisted cores.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure 4-70.
483