Huawei NE05E Hardware Manual page 500

HUAWEI NE05E,NE08E
Hardware Guide
Step 3 Hold the RJ45 connector. Observe the side and front of the metal contact slice,
and check for any perceptible object, dirt or rust. Remove the perceptible object,
dirt or rust, if there is any. If the removal fails, replace RJ45 connector and
assemble the connector again. Otherwise, the connector is unqualified. See
4-87.
Figure 4-87 Metal contact slices with perceptible object, dirt or rust on the surface
Step 4 Hold the RJ45 connector. Observe the side and front of the metal contact slices,
and observe the plastic spacers. Make sure they are intact and do not tilt. If they
tilt or are not intact, rectify the RJ45 connector. If the rectification fails, replace the
RJ45 connector and assemble the connector again. Otherwise, the connector is
unqualified. See
Figure 4-88 RJ45 connector with tilted plastic spacers
Step 5 Hold the RJ45 connector and observe the side to check whether you can see the
core section. Make sure that the end of the cable core is close to the face of the
cable trough of the connector. The metal contact should be higher than the end of
the cable core, and be properly crimped to the cable core. If the RJ45 connector
does not meet this requirement, replace the RJ45 connector and assemble the
connector again. Otherwise, the RJ45 connector is intact. See
Issue 05 (2023-03-31)
Figure 4-88.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure
Figure 4-89.
492