Huawei NE05E Hardware Manual page 508

HUAWEI NE05E,NE08E
Hardware Guide
Figure 4-99 Putting a cable into a cord end terminal
After the cord end terminal is assembled, the exposed part of the conductor
should not be more than 1 mm.
Step 3 Press-fit the joint parts of the cord end terminal and the conductor using soldering
tool, as shown in
Figure 4-100 Press-Fitting a cord end terminal and a power cable
Step 4 After press-fitting the terminal, check the maximum width of the press-fit part.
The width of the tubular terminal after press-fit should be less than the maximum
width described in
Table 4-37 Maximum width of tubular terminal after press-fit
Cross-Sectional Area of Tubular
Terminal(mm
0.25
Issue 05 (2023-03-31)
NO TICE
Figure
Table 4-37
2
)
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
4-100.
Maximum Width of Terminal after
Press-Fit(mm)
1
500