Thermostat - Honda SH125 Manual

COOLING SYSTEM
Fill the reserve tank to the upper level line and
install the tank cap.
Bleed air from the system as follows:
1. Start the engine and let
it
idle for 2
-
3 minutes.
2. Snap the throttle 3
-
4 times t o bleed air from the
system.
3. Stop the engine and add coolant u p t o the filler
neck.
4. Install the radiator cap.
Install the front upper cover (page 2-8).
THERMOSTAT
REMOVALA NSTALLATION
Drain the coolant f r o m the system (page 6-8).
Remove the maintenance lid (page 2-4).
Remove the following:
-
spark plug cap
-
wire band (from the stay)
Place
a
shop towel
-
t w o bolts
under the thermo-
-
wire retaining stay
stat housing.
-
thermostat cover
-
thermostat
Installation is in the reverse order of removal.
NOTE:
The thermostat is installed with the bleed hole
Fill and bleed the cooling system (page 6-7).
facing up.
6-9