Oil Cooler - Honda CBR650F Service Manual

dummyhead dummyhead
LUBRICATION SYSTEM
Install the oil pan [1] and bolts [2] to the crankcase.
Tighten the bolts in a crisscross pattern in 2 or 3 steps.
Install the exhaust pipe/muffler (page 2-18).
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-9).

OIL COOLER

REMOVAL/INSTALLATION
Drain the engine oil (page 3-9).
Drain the coolant from the system (page 8-4).
Remove the bolt [1], sealing washer [2] and oil cooler
[3].
Disconnect the oil cooler water hoses [4] from the oil
cooler.
Remove the O-ring [1] from the oil cooler.
Installation is in the reverse order of removal.
• Apply engine oil to a new O-ring.
• Align the oil cooler groove with the crankcase boss.
• Apply engine oil to the oil cooler bolt threads and a
new sealing washer seating surface.
TORQUE:
Oil cooler bolt: 59 N·m (6.0 kgf·m, 44 lbf·ft)
Fill the crankcase with the recommended oil (page 3-9).
Fill the cooling system and bleed any air (page 8-4).
Check that there is no oil leaks.
9-8
[2]
[1]
[1]
[3]
[2]
Align
[1]
[4]