Extension Setting - Mitsubishi Electric FATEC MELSEC iQ-R Training Manual

4.8.3

Extension setting

(The device cannot be changed while the programmable controllers is in the ready state.)
Parameters
[PC01] Error excessive alarm level
Electromagnetic brake sequence
[PC02]
output
Encoder output
[PC03]
pulse selection
[PC04] Function selection C-1
Function
[PC05]
selection C-2
[PC06] Function selection C-3
[PC07] Zero speed
[PC08] Overspeed alarm detection level
Item
Encoder output
pulse phase
selection
Encoder output
pulse setting
*1
selection
Selection of the
encoders for
encoder output
pulse
*2
Motor-less
operation selection
[AL. 9B Error
*2
excessive
warning] selection
*2
Setting range
1 to 1000 [rev]/[mm]
0 to 1000 [ms]
0: Increasing A-phase 90° in CCW or positive
direction
1: Increasing A-phase 90° in CW or negative
direction
0: Output pulse setting
1: Division ratio setting
3: A-phase/B-phase pulse electronic gear
setting
4: A/B-phase pulse through output setting
0: Servo motor encoder
1: Load-side encoder
0: Two-wire type
1: Four-wire type
0: Disable
1: Enable
0: [AL. 9B Error excessive warning] disabled
1: [AL. 9B Error excessive warning] enabled
0: Per 1 rev or 1 mm
1: Per 0.1 rev or 0.1 mm
2: Per 0.01 rev or 0.01 mm
3: Per 0.001 rev or 0.001 mm
0 to 10000 [r/min]/[mm/s]
0 to 20000 [r/min]/[mm/s]
4-53
Default
value
0
0
0
0
0
0
0
0
0
50
0