Extension Stage Number Setting For The Extension Base Unit - Mitsubishi Electric MELCEC Q Series User Manual

9. LOADING AND INSTALLATION
9.1.5

Extension stage number setting for the extension base unit

When using two or more extension base units, the extension stage numbers should be set
with the stage number setting connectors of the extension base units. As the extension
stage number is set to "1" at shipment, the first extension base unit has not to be set.
Set the extension stage number as follows.
(1)
(2)
(3)
The stage number setting connector is located inside the base cover of the IN
connector of the extension base unit. For the extension stage number setting, refer to
Section 6.3.
First, loosen the upper and lower screws on the base cover of the IN connector, and
remove the base cover from the extension base unit.
Insert a connector pin at the position of the desired stage number in the connector
(PIN1) located between the IN and OUT extension cable connectors.
Attach the base cover to the extension base unit and tighten the screws.
OUT
9 - 11