Mitsubishi Electric FATEC MELSEC iQ-R Training Manual page 319

(3) Set the CPU module to "RUN".
[Servo ON]
(4) If the servo is not on, touch
demonstration machine operation panel.
The servo status for axes 1 to 3 changes to ready.
Advanced
(5) Touch
synchronous control 1
[Switching to advanced synchronous control 1 and clutch operation]
Advanced 1
(6) Touch on the Advanced synchronous control 1 screen. And the, touch
M6802
Start up advanced 1
Next, touch
M31
Touch to ensure that conveyor speed change operation is possible.
Clutch ON
Touch , and ensure that clutch operation is possible.
M32
Clutch ON
• Touch during operation with advanced synchronous control.
M32
This turns off the clutch and the cutting movement (the rotation of the disc) stops.
Touching the switch for
* The clutch can turn on and off the cutter shaft only. (It does not turn on and off the travel shaft.)
Error check operation
Simple Motion setting tool
[Navigation window]
⇓
[Module monitor]
⇓
[Starting history]
From previous page
Servo ON
at the
M1000
.
to start up the demonstration machine.
Clutch OFF
again causes the disc to start the cutting movement again.
M32
Starting history
Go to next page
Demonstration machine
operation panel
7-68
Home position return
.
M30