Mitsubishi Electric FATEC MELSEC iQ-R Training Manual page 415

(4) Waveform measurement
(1) Execute the standby point positioning to set the positioning address to (0, 0). (Refer to Section 6.8.4)
(3) Execute the address indirect specification positioning (refer to Section 6.8.6).
Set any positioning address, and touch
A trigger is generated at the same time when
obtained.
(4) After the data is obtained, sampling will be automatically stopped, and the sampling data will be read.
After the completion of reading, the waveforms of sampled word data and bit data will be displayed in the
waveform display area.
The waveforms of address indirect designation positioning are shown after the trigger cursor [T].
(2) Select [Action] in the Digital oscilloscope window,
and click [Run].
Sampling is started.
Click!
Position selection
to execute the positioning.
M1
Position selection
is touched, and data for sample size is
M1
App-65