Mitsubishi Electric FX2N-10GM User Manual

This manual only describes the specifications for FX
For complete operation, wiring, mounting and programming instructions please refer to the FX
-20GM HARDWARE PROGRAMMING MANUAL, FX PROGRAMMING MANUAL ΙΙ and FX SERIES
FX
2N
HARDWARE MANUAL.
These manuals should be read and understood before attempting to install or use the unit.
And, store this manual in a safe place so that you can take it out and read it whenever necessary. Always
forward it to the end user.
Safety Precaution
This manual classifies the safety precautions into two categories:
Indicates that incorrect handling may cause hazardous conditions, resulting in death or
severe injury.
Indicates that incorrect handling may cause hazardous conditions, resulting in medium or
slight personal injury or physical damage.
Depending on the circumstances, procedures indicated by
It is important to follow all precautions for personal safety
DESIGN PRECAUTIONS
• Install a safety circuit outside the PLC so that the entire system conservatively operates even if an
abnormality occurs in the external power supply or a failure occurs in the PLC.
If the safety circuit is installed inside the PLC, malfunction and erroneous output may cause
accidents.
STARTUP AND MAINTENANCE
PRECAUTIONS
• Do not touch any terminal while the FX
Doing so may cause electric shock or malfunctions.
• Before cleaning or retightening terminals externally cut off all phases of the power supply.
Failure to do so may cause electric shock.
• Thoroughly read the manual, sufficiently confirming safety, then perform returning to the zero point
in the MANU/AUTO mode, jog operation, step operation or automatic operation.
An operation error may damage the machinery or cause accidents.
STARTUP AND MAINTENANCE
PRECAUTIONS
• Do not disassemble or modify the FX
Doing so may cause fire, equipment failures, or malfunctions.
For repair, contact your local Mitsubishi Electric distributor.
• Turn off the power to the FX
extension cable.
Failure to do so may cause equipment failures or malfunctions.
• Turn off the power to the FX
following devices.
Failure to do so may cause equipment failures or malfunctions.
- Peripheral devices, FX Series terminal blocks
DISPOSAL PRECAUTIONS
• Please contact a certified electronic waste disposal company for the environmentally safe recycling
and disposal of your device.
(Read these precautions before use.)
2N
-10GM positioning controller before connecting or disconnecting any
2N
-10GM positioning controller before attaching or detaching the
2N
FX
USER'S GUIDE
-10GM positioning controller.
2N
-10GM positioning controller's power is on.
2N
-10GM positioning controller.
-10GM
2N
JY992D77701J
and
may also cause severe injury.
-10GM,
2N
.