Stratasys J850 User Manual page 128

Stratasys J850/J835 User Guide
You can postpone the automatic flushing process up to 2 times. After that
you cannot print until the pre-heater is flushed.
When printing in High Speed mode or Super High Speed mode for long
periods of time, it is recommended to load cleaning fluid cartridges in the
channels that are not in use to reduce material costs.
To flush the print block pre-heater:
1. When the following message appears, prepare the cartridges as listed in
DOC-18001 Rev. N
the message.
Figure 4-147 Initial flushing alert message (sample)
❒ Click Yes to flush the pre-heater.
❒ Click No to postpone the flushing of the pre-heater. You can postpone
the automatic flushing up to 2 times.
After postponing the automatic flushing process 2 times, flushing is
required and the following screen appears.
Figure 4-148 Flushing alert message after postponement (sample)
4 Operating and Maintaining the Printer
4-97