Table of Contents
Advertisement
Stratasys J850/J835 User Guide
7. In the Cartridge Positioning screen, make sure that the material cartridges
Symbols:
8. Click Start.
9. Read the warning message, and click OK.
10. Click Done.
Returning to the previous mode
To return to the High Speed or Super High Speed printing mode:
1. Run the Material Replacement wizard again.
2. In the Material Replacement Options screen, select the required printing
DOC-18001 Rev. N
are properly positioned.
Figure 4-154 Cartridge Positioning screen
The correct cartridge is in this slot.
No cartridge (or the incorrect cartridge) is in this slot.
The cartridge in this slot has insufficient weight to complete the material
replacement process.
The expiration date of the cartridge in this slot has passed.
Note: The time needed to complete this process depends on the materials
currently loaded in the printer. The estimated time is displayed at the bottom
of the Cartridge positioning screen.
The wizard drains the model materials from the print block and fills it with
the selected materials.
When the process is finished, the Wizard Completed screen appears.
The printer application restarts, and it is now in High Mix / High Quality
mode, using all seven material loaded in the printer.
mode and materials, and select the Economy flushing cycle.
4 Operating and Maintaining the Printer
4-101
Advertisement
Table of Contents
