Table of Contents
Advertisement
Stratasys J850/J835 User Guide
5. Loosen the two screws securing the suction tube on the print block.
6. Lift the suction tube to secure it in a raised position.
7. Remove the two screws securing the covering of the roller waste collector
Be very careful to save the covering screws. These are special screws; if
they are lost, you need to order replacements.
8. Remove the covering by pulling it out, and then lower it.
DOC-18001 Rev. N
Figure 4-76 Lifting the suction tube
and remove it.
Figure 4-77 Removing the roller waste collector screws
4 Operating and Maintaining the Printer
4-56
Advertisement
Table of Contents
